1/4″ Brass Electric Solenoid Valve 12V DC Normally closed 230 PSI VITON Water Air Oil

U.S. Solid normally closed (N/C) electric solenoid valve is constructed with a durable brass body, one-quarter inch (1/4″) female threaded (NPT) connections, and VITON gasket.

Suitable for use with hot or cold water, natural gas, air, very low viscosity fluids (<20 cst) and gasoline or other petroleum based liquids. Customers chose this general purpose valve for supplemental gas tanks, sprinkler systems, and more. Can not be used in strong acid, strong base, waste water, industrial gas and other media containing many impurities. Suitable for outdoor use; not for use underwater.

Brand: U.S. Solid

Model: USS2-00024

Size: 1/4″

Flow Aperture: 12 mm

Body Material: Brass

Gasket / Diaphragm / Seal: VITON

Rated voltage: DC 12 V, ± 10%

Current: 1 A

Power rating: 12 W

Operation Type: Pilot

Operation Mode: Normally Closed

Operational pressure range: 10 PSI to 232 PSI (0.07 MPa to 1.6 MPa)

Flow capacity: 1.5 gallons per minute (GPM) of water at 60oF with a pressure drop of 1 PSI

Flow value: 1.5 Cv

Minimum operational temperature: 14 degrees Fahrenheit (-10 degrees Celsius)

Maximum operational temperature: 248 degrees Fahrenheit (120 degrees Celsius)

Suitable Media: Air, water, oil, natural gas, diesel fuel, kerosene etc.

OVERHEATING WARNING: Not designed for continuous operation(not a 100% duty cycle). While energized, under normal operating conditions, solenoid valve will get HOT. The coil will reach a maximum temperature of about 80℃. It is fully complied with national standard: JB/T7352-2010. If energized continuously for more than 8h the coil may burn.

Make sure this fits by entering your model number.
1/4″ NPT THREAD- Commonly used standard pipe thread in U.S..
Constructed of industrial grade brass, this valve is corrosion resistant, more conducive for welding, optimal for higher temperature projects, and can be used with gasoline, diesel fuel, kerosene oil, natural gas, air etc. Due to the chemical composition of brass, this valve should NOT be used with projects involving drinking water or other water projects.
This valve was manufactured with a VITON seal. VITON is the most durable and high performance rubber material with the ability to resist high temperatures and corrosive chemicals and other fluids like gasoline, diesel fuel, oils, and lubricants.
This highly responsive valve will open and close in less than 1 second when actuated; meaning it will open or close the flow instantaneously when energized or de-energized. Also, our U.S. SOLID engineers have determined that the life cycle of this valve is well over a million cycles with proper operating conditions and maintenance.
PLEASE NOTE: This valve is NOT a continuous duty valve and should NOT be in continuous use for more than 8 hours in a single cycle; to do so will shorten the life of the valve and may cause the core of the valve to burn out. If you need a continuous duty valve for your project please search for our U.S. SOLID Motorized Ball Valves.